In general, most racing harnesses should be universally compatible with the E-Racer. The R300 seat features harness openings on both sides of the seat base as well as in the upper center area of the backrest.
The harness openings measure approximately 9.5 cm × 3 cm (rounded on the R300 seat), meaning harnesses up to 9–9.5 cm in width should fit without issues.
Related to:
Articles in this section
- Can the supplied screws, spacers and washers be combined during installation?
- What should I do if my seat does not appear perfectly aligned after installation?
- Can I install a third-party seat on a Nitro Concepts racing rig?
- Are small alignment adjustments during assembly normal?
- Can the seating position be adjusted after installation?
- Should I fully tighten all screws during assembly right away?
- Are extension cables available for the LED strips?
- Can the IMMERSION Metahaptics be used together with other bass shakers in SimHub?
- Which VESA mounting patterns are supported by the Nitro Concepts Monitor Stand, and do I need an adapter?
- What should I check if my IMMERSION devices are not working as expected?