Yes. The IMMERSION Metahaptics support individual channel mapping, allowing each actuator zone to be configured independently within supported software such as SimHub.
The available channel mapping is as follows:
- Seat Front Left
- Seat Front Right
- Backrest Bottom Left
- Backrest Bottom Right
- Backrest Top Left
- Backrest Top Right
- Seat Left Mid
- Seat Right Mid
More information can be found on the official IMMERSION Metahaptics product page.
Related to:
Articles in this section
- Can the supplied screws, spacers and washers be combined during installation?
- What should I do if my seat does not appear perfectly aligned after installation?
- Can I install a third-party seat on a Nitro Concepts racing rig?
- Are small alignment adjustments during assembly normal?
- Can the seating position be adjusted after installation?
- Should I fully tighten all screws during assembly right away?
- Are extension cables available for the LED strips?
- Can the IMMERSION Metahaptics be used together with other bass shakers in SimHub?
- Which VESA mounting patterns are supported by the Nitro Concepts Monitor Stand, and do I need an adapter?
- What should I check if my IMMERSION devices are not working as expected?